Input Function Target 2; Input Function Command 2; Input Function Target 3; Output Function Assigned - Toshiba H9 ASD Installation And Operation Manual

F902

Input Function Target 2

Program My Function My Function Unit 1
This parameter plays a role in the setup of the My Function feature by
selecting the functionality of the programmable Input Function Target 2
terminal.
This setting assigns the function of the programmable Input Function Target 2
terminal to any one of the user-selectable functions listed in
Table 8 on pg. 239, or
See F977 for more information on this parameter.

Input Function Command 2

Program My Function My Function Unit 1
This parameter is used to assign a user-selected logical operator to two user-
selected Input Function Target variables, enable a counter/timer function, or
perform a hold/reset function.
Table 11 on pg. 243 lists the available selections. Their use and selection
requirements are described in an example at F977.

Input Function Target 3

Program My Function My Function Unit 1
This parameter plays a role in the setup of the My Function feature by
selecting the functionality of the programmable Input Function Target 3
terminal.
This setting assigns the function of the programmable Input Function Target 3
terminal to any one of the user-selectable functions listed in
Table 8 on pg. 239, or
See F977 for more information on this parameter.

Output Function Assigned

Program My Function My Function Unit 1
This parameter plays a role in the setup of the My Function feature by
selecting the functionality of the Output Function Assigned terminal.
This setting assigns the function of the programmable Output Function
Assigned data location to one of the functions listed in the Input Setting field
of Table 7 on pg. 238.
Settings:
0 – 3099
See the My Function Instruction Manual (P/N E6581335) and
information on this parameter.
214
Phone: 800.894.0412 - Fax: 888.723.4773 - Web: www.ctiautomation.net - Email: info@ctiautomation.net
Table 10 on pg. 241.
Table 10 on pg. 241.
Direct Access Number — F902
Parameter Type — Selection List
Factory Default — 0 (Disabled)
Changeable During Run — Yes
Table 7 on pg. 238,
Direct Access Number — F903
Parameter Type — Selection List
Factory Default — 0 (NOP)
Direct Access Number — F904
Parameter Type — Selection List
Factory Default — 0 (Disabled)
Changeable During Run — Yes
Table 7 on pg. 238,
Direct Access Number — F905
Parameter Type — Selection List
Factory Default — 0 (Disabled)
Changeable During Run — Yes
F977 for more
H9 ASD Installation and Operation Manual
F905