Toshiba H9 ASD Installation And Operation Manual page 256

LED Screen
E-25
E-26
E-50/E-51
EEP1
EEP2/EEP3
EF1/EF2
EPHI
EPHO
ERR2
ERR3
ERR4
ERR5
ERR6
ERR7
ERR8
ERR9
H9 ASD Installation and Operation Manual
Phone: 800.894.0412 - Fax: 888.723.4773 - Web: www.ctiautomation.net - Email: info@ctiautomation.net
LCD Screen
Stop Positioning • Load movement while stopped.
Retention Error
• F381
• Encoder malfunction.
• Creep speed is too high.
CPU2 Fault • CPU malfunction.
• Control board malfunction.
Sink/Source Setting • Improperly positioned Sink/Source jumper on the Terminal board or on an
Error option device (see J100 at the Terminal PCB of the ASD).
• Sink/Source configuration is incorrect.
EEPROM Fault • EEPROM write malfunction.
• Make a service call.
EEPROM Read Error • EEPROM read malfunction.
• Make a service call.
(Earth) Ground Fault • Ground fault at the motor.
• Ground fault at the output of the ASD.
• Current leakage to Earth Ground.
Input Phase Failure • 3-phase input to the ASD is low or missing at the R, S, or T input terminals.
Output Phase Failure • 3-phase output from the ASD is low or missing at the U, V, or W output
terminals or at the input to the motor.
RAM Fault • Internal RAM malfunction.
• Make a service call.
ROM Fault • Internal ROM malfunction.
• Make a service call.
CPU Fault • CPU malfunction.
• Control board malfunction.
• Make a service call.
Communication Error • Communication time out error.
• Communication malfunction.
• Improper or loose connection.
• Improper system settings.
Gate Array Fault • Main Gate Array is defective.
Low -Current • Improper Low- Current detection level settings at
Option Device Fault • Check installation, connections, and option device manual.
Flash Memory Fault • Flash memory malfunction.
• Make a service call.
Possible Causes
setting is too low.
F609 – F612.
249