Sip Settings/Tcp And Tls; Table 88: Sip Settings/Tcp And Tls - Grandstream Networks UCM6102 User Manual

Session Expire
Min SE
Session Refresher

SIP SETTINGS/TCP AND TLS

TCP Enable
TCP Bind Address
TLS Enable
TLS Bind Address
TLS Client Protocol
TLS Do Not Verify
TLS Self-Signed CA
Firmware Version 1.0.9.26
Configure the maximum session refresh interval (in seconds). The default
setting is 1800.
Configure the minimum session refresh interval (in seconds). The default
setting is 90.
Select the session refresher to be UAC or UAS. The default setting is
UAC.

Table 88: SIP Settings/TCP and TLS

Configure to allow incoming TCP connections with the UCM6100. The
default setting is "No".
Configure the IP address for TCP server to bind to. 0.0.0.0 means binding
to all interfaces. The port number is optional. If not specified, 5060 will be
used.
Configure to allow incoming TLS connections with the UCM6100. The
default setting is "No".
Configure the IP address for TLS server to bind to. 0.0.0.0 means binding
to all interfaces. The port number is optional. If not specified, 5061 will be
used.
Note:
The IP address must match the common name (hostname) in the
certificate. Please do not bind a TLS socket to multiple IP addresses. For
details on how to construct a certificate for SIP, please refer to the
following document:
http://tools.ietf.org/html/draft-ietf-sip-domain-certs
Select the TLS protocol for outbound client connections. The default
setting is TLSv1.
If enabled, the TLS server's certificate won't be verified when acting as a
client. The default setting is "Yes".
This is the CA certificate if the TLS server being connected to requires
self-signed certificate, including server's public key. This file will be
renames as "TLS.ca" automatically.
Note:
The size of the uploaded ca file must be under 2MB.
UCM6100 Series IP PBX User Manual Page 261 of 305