External Number
Time Condition for Ring
Simultaneously
Other Settings
Ring Timeout
Auto Record
Skip Trunk Auth
Time Condition for Skip Trunk
Auth
Dial Trunk Password
Specific Time
Time Condition
CREATE NEW FXS EXTENSION
The UCM6100 supports Foreign eXchange Subscriber (FXS) interface. FXS is used when user needs to
connect analog phone lines or FAX machines to the UCM6100.
Firmware Version 1.0.9.26
number.
Set the external number to be rang simultaneously. '-' is the connection
character which will be ignored.
Ring the external number simultaneously along with the extension on the
basis of this time condition.
Configure the number of seconds to ring the user before the call is
forwarded to voicemail (voicemail is enabled) or hang up (voicemail is
disabled). If not specified, the default ring timeout is 60 seconds on the
UCM6100, which can be configured in the global ring timeout setting
under web GUI->Internal Options->IVR Prompt: General Preference. The
valid range is between 5 seconds and 600 seconds.
Note:
If the end point also has a ring timeout configured, the actual ring timeout
used is the shortest time set by either device.
Enable automatic recording for the calls using this extension. The default
setting is disabled. The recording files can be accessed under web
GUI->CDR->Recording Files.
If set to "Yes", users can skip entering the password when making
outbound calls.
If set to "By Time", users can skip entering the password when
making outbound calls during the selected time condition.
If set to "No", users will be asked to enter the password when making
outbound calls.
If "Skip Trunk Auth" is set to "By Time", select a time condition during
which users can skip entering password when making outbound calls.
Configure personal password when making outbound calls via trunk.
Table 41: IAX Extension Configuration Parameters - Specific Time
Click to add Time Condition to configure specific time for this extension.
UCM6100 Series IP PBX User Manual
Page 131 of 305