Ring Group; Configure Ring Group; Table 66: Ring Group Parameters - Grandstream Networks UCM6102 User Manual

The UCM6100 supports ring group feature with different ring strategies applied to the ring group members.
This section describes the ring group configuration on the UCM6100.

CONFIGURE RING GROUP

Ring group settings can be accessed via Web GUI->PBX->Call Features->Ring Group.

Click on "Create New Ring Group" to add ring group.

Click on to edit the ring group. The following table shows the ring group configuration parameters.

Click on to delete the ring group.
Ring Group Name
Extension
Ring Group Members
Selected LDAP Numbers
Ring Strategy
Firmware Version 1.0.9.26

RING GROUP

Figure 111: Ring Group

Table 66: Ring Group Parameters

Configure ring group name to identify the ring group. Letters, digits, _ and
– are allowed.
Configure the ring group extension.
Select available users from the left side to the ring group member list on
the right side. Click on
Select available remote users from the left side to the ring group member
list on the right side. Click on
LDAP Sync must be enabled first.
Select the ring strategy. The default setting is "Ring in order".

Ring simultaneously.
Ring all the members at the same time when there is incoming call to
the ring group extension. If any of the member answers the call, it will
stop ringing.

Ring in order.
Ring the members with the order configured in ring group list. If the
first member doesn't answer the call, it will stop ringing the first
member and start ringing the second member.
UCM6100 Series IP PBX User Manual
to arrange the order.
to arrange the order. Note:
Page 197 of 305