Grandstream Networks UCM6102 User Manual page 246

Feature Code Digits Timeout
Call Park
Parked Lots
Use Parklot as Extension
Parking Timeout (s)
Feature Codes
Voicemail Access Code
My Voicemail
Agent Pause
Agent Unpause
Paging Prefix
Intercom Prefix
Firmware Version 1.0.9.26

Default Setting: 1000.

Configure the maximum interval (in milliseconds) between the
digits input to activate the feature code.

Default Extension: 700.

During an active call, initiate blind transfer and then enter this
code to park the call.

Default Extension: 701-720.

These are the extensions where the calls will be parked, i.e.,
parking lots that the parked calls can be retrieved.

If checked, the parking lot number can be used as extension.
The user can transfer the call to the parking lot number to park
the call. Please note this parking lot number range might
conflict with extension range.

Default setting: 300.

This is the timeout allowed for a call to be parked. After the
timeout, if the call is not picked up, the extension who parks the
call will be called back.

Default Code: *98.

Enter *98 and follow the voice prompt. Or dial *98 followed by
the extension and # to access the entered extension's
voicemail box.

Default Code: *97.

Press *97 to access the voicemail box.

Default Code: *83.

Pause the agent in all call queues.

Default Code: *84.

Unpause the agent in all call queues.

Default Code: *81.

To page an extension, enter the code followed by the extension
number.

Default Code: *80.

To intercom an extension, enter the code followed by the
extension number.
UCM6100 Series IP PBX User Manual Page 245 of 305