Inbound Route: Prepend Example - Grandstream Networks UCM6102 User Manual

Strip
Prepend
Prepend Trunk Name
Dial Trunk
DID Destination
Alert-Info
Time Condition
Time Conditions
Destination

INBOUND ROUTE: PREPEND EXAMPLE

UCM6100 now allows user to prepend digits to an inbound DID pattern, with strip taking precedence over
prepend. With the ability to prepend digits in inbound route DID pattern, user no longer needs to create
Firmware Version 1.0.9.26
based on the number dialed, which could be local extensions,
conference, call queue, ring group, paging/intercom group, IVR,
voicemail groups and Fax extension as configured in "DID
destination". If the dialed number matches the DID pattern, the call
will be allowed to go through.
Configure the number of digits to be stripped from the beginning of the
DID. This option shows up only when "By DID" is selected.
Configure the number of digits to be prepended to an inbound DID
pattern, with strip taking precedence over prepend.
This option shows up only when "By DID" is selected. If enabled, the trunk
name will be prepended to the display name.
This option shows up only when "By DID" is selected. If enabled, the
external users dialing in to the trunk via this inbound route can dial
outbound call using the UCM6100's trunk.
This option shows up only when "By DID" is selected. This controls the
destination that can be reached by the external caller via the inbound
route. The DID destination are:

Extension

Conference

Call Queue

Ring Group

Paging/Intercom Groups

IVR

Voicemail Groups

Fax Extension

Dial By Name

All
When present in an INVITE request, the Alert-Info header field specifies
an alternative ring tone to the UAS.
Select the time condition for the inbound rule.
Select the destination for the inbound call during the specified time
condition.
UCM6100 Series IP PBX User Manual Page 175 of 305