Ivr; Configure Ivr; Table 61: Ivr Configuration Parameters - Grandstream Networks UCM6102 User Manual

CONFIGURE IVR

IVR configurations can be accessed under the UCM6100 Web GUI->PBX->Call Features->IVR. Users
could create, edit, view and delete an IVR.

Click on "Create New IVR" to add a new IVR.

Click on to edit the IVR configuration.

Click on to delete the IVR.
Basic Settings
Name
Extension
Dial Other Extensions
Dial Trunk
Permission
Welcome Prompt
Digit Timeout
Response Timeout
Firmware Version 1.0.9.26

IVR

Table 61: IVR Configuration Parameters

Configure the name of the IVR. Letters, digits, _ and - are allowed.
Enter the extension number for users to access the IVR.
If enabled, all callers to the IVR can dial other extensions. The default
setting is "No".
If enabled, all callers to the IVR is allowed to use trunk. The permission
must be configured for the users to use the trunk first. The default setting
is "No".
Assign permission level for outbound calls if "Dial Trunk" is enabled. The
available permissions
"International" from the lowest level to the highest level. The default
setting is "Internal". If the user tries to dial outbound calls after dialing into
the IVR, the UCM6100 will compared the IVR's permission level with the
outbound route's privilege level. If the IVR's permission level is higher
than (or equal to) the outbound route's privilege level, the call will be
allowed to go through.
Select an audio file to play as the welcome prompt for the IVR. Click on
"Prompt" to add additional audio file under web GUI->Internal
Options->IVR Prompt.
Configure the timeout between digit entries. After the user enters a digit,
the user needs to enter the next digit within the timeout. If no digit is
detected within the timeout, the UCM6100 will consider the entries
complete. The default timeout is 3 seconds.
After playing the prompts in the IVR, the UCM6100 will wait for the DTMF
UCM6100 Series IP PBX User Manual
are "Internal", "Local", "National" and
Page 185 of 305