Batch Add Iax Extensions; Table 47: Batch Add Iax Extension Parameters - Grandstream Networks UCM6102 User Manual

1ghz arm cortex a8 application processor, 512mb ddr ram, 4gb nand flash
Hide thumbs Also See for UCM6102:
Table of Contents

Advertisement

SRTP
Fax Mode
Strategy
Skip Trunk Auth
Codec Preference

BATCH ADD IAX EXTENSIONS

Under Web GUI->PBX->Basic/Call Routes->Extensions, click on "Batch Add Extensions"->"Batch Add
IAX Extensions".
General
Start Extension
Create Number
Permission
Firmware Version 1.0.9.26
Enable SRTP for the call. The default setting is "No".
Select Fax mode for this user. The default setting is "None".
None: Disable Fax.
Fax Detect: Fax signal from the user/trunk during the call can be
detected and the received Fax will be sent to the Email address
configured for this extension. If no Email address can be found for the
user, the Fax will be sent to the default Email address configured in
Fax setting page under web UI->PBX->Internal Options->Fax/T.38.
This option controls how the extension can be used on devices within
different types of network.
Allow All
Device in any network can register this extension.
Local Subnet Only
Only the user in specific subnet can register this extension. Up to
three subnet addresses can be specified.
A Specific IP Address.
Only the device on the specific IP address can register this extension.
The default setting is "Allow All".
If enable "All", users do not need to enter password when making an
outbound call. If enable "Follow Me", the user can dial out via follow me
without password.
Select audio and video codec for the extension. The available codecs are:
PCMU, PCMA, GSM, AAL2-G.726-32, G.722, G.729, G.723, iLBC,
ADPCM, LPC10, H.264, H.263 and H.263p.

Table 47: Batch Add IAX Extension Parameters

Configure the starting extension number of the batch of extensions to be
added.
Specify the number of extensions to be added. The default setting is 5.
Assign permission level to the user. The available permissions are
"Internal", "Local", "National" and "International" from the lowest level to
the highest level. The default setting is "Internal".
UCM6100 Series IP PBX User Manual
Page 139 of 305

Hide quick links:

Advertisement

Table of Contents

Troubleshooting

loading

This manual is also suitable for:

Ucm6104Ucm6108Ucm6116

Table of Contents