Setting Ipsi Duplication (High/Critical Reliability Only) - Avaya S8700 Series Manual

S8700 only
3. Verify the correct setting for the IP Control? field
If IPSIs are in IP-connected PNs, then set the IP Control? field to y.
If IPSIs are in fiber-connected PNs (CSS or ATM), then set the IP Control? field to y.
If IPSIs are in fiber-connected PNs (direct-connect), then set the IP Control? field to y
unless there is more than 1 IPSI. Then set the IP Control? field for the second IPSI to n.
If an IPSI is in a DS1-C–remoted PN, then set the IP Control? field to n to maintain the
5:1 ratio of IPSIs to PNs. If the field is set to y, then the system decreases the ratio to 2:1.
4. Verify that all the other fields are populated.
5. Press Enter to effect the changes.
6. Repeat steps 1 through 5 for each port network.

Setting IPSI duplication (high/critical reliability only)

To set IPSI duplication:
1. Type change system-parameters duplication and press Enter
S8700 MC:
change system-parameters duplication
Enable Operation of PNC Duplication? y
Enable Operation of IPSI Duplication? y
DUPLICATION RELATED SYSTEM PARAMETERS
Migrating translations
Page 1 of 1
Issue 4 January 2005 55