General Information
Mounting Surface Specifications
1-18
These specifications apply to any printer used as a table-top printer.
1.
Mounting surface flatness must be within the specified range.
Right Hand Side
5mm Max
2.
The printer must not be tipped or tilted more than 7 mm.
10° or 7 mm
10° or 7 mm
Failure to adhere to the specified mounting specifications will void all
guarantees of print-quality and/or performance. Known problems that can
occur as a result of exceeding the mounting surface specifications are:
Color-to-Color mis-registration, primarily in the horizontal (laser scan)
direction.
A smear or line of toner approximately 40 mm from the trailing edge of the
print.
s6180-263
s6180-262
Phaser 6130 Color Laser Printer Service Manual