Abnormal Noise During Printing - Xerox Phaser 6130 Service Manual

General Troubleshooting

Abnormal Noise During Printing

4-46
Troubleshooting Reference Table
Applicable Parts
Separator Roller Assembly (PL2.1.5)
Feed Roller Assembly (PL3.2.4)
Imaging Unit (PL4.1.21)
Fuser (PL6.1.1)
Transfer Unit (PL6.1.7)
Sub Drive Assembly (PL7.1.1)
Main Drive Assembly (PL7.1.2)
Fan (PL8.1.1)
Troubleshooting Procedure Table
Step Actions and Questions
Is the noise present when paper is fed from
1
the Tray?
2 Check the paper condition in the Tray
Is the paper dry and approved paper?
3 Check noise when the paper is fed from the
Tray 1
Is the noise still present?
4 1. Remove the Paper Tray from the printer.
2. Rotate the Separator Roller in the Paper
Tray with your finger.
Does the Separator Roller rotate smoothly?
5 Check the Feed Roller Assembly for rotation
1. Remove the Paper Tray from the printer.
2. Start the Main Motor FULL2 test
(page 4-27): Service Mode
Diag > Motor Test
then while the motor is running, start the
Tray Feed Solenoid (Auto) test
(page 4-34): Service Mode
Diag > Motor Test
(Auto).
Is the noise coming from this Roller?
NOTE: After check is completed, turn off the
Tray Feed Solenoid test first, then turn off
the Main Motor FULL2 test.
Wiring and Plug/Jack Map References
Yes
Go to step 2.
Go to step 4.
Go to step 4.
Go to step 5. Replace the
Replace the
Feed Roller
Assembly
(page 8-30).
> Engine
> Main Motor FULL2,
> Engine
> Tray Feed Solenoid
Phaser 6130 Color Laser Printer Service Manual
No
Go to step 6.
Replace with
dry and
approved
paper, then
go to step 3.
Complete
Separator
Roller
Assembly
(page 8-7).
Go to step 9.