Mcu Nvram Error - Xerox Phaser 6130 Service Manual

MCU NVRAM Error

Phaser 6130 Color Laser Printer Service Manual
Engine NVRAM is corrupted.
Applicable Chain Link
041-340: MCU NVRAM Error
Initial Actions
Cycle printer power.
If the problem persists, follow the procedure below.
Troubleshooting Reference Table
Applicable Parts
Toner Cartridge, PL5.1.21/5.1.22/
5.1.23/5.1.24
Transfer Unit, PL6.1.7
MCU Board, PL8.2.13
Note
Press the
display error code detail called for in this procedure.
Troubleshooting Procedure Table
Step Actions and Questions
Check the error
1
Does the error still occur when turning
off and on the power?
2 Check the failure parts
Is the "ADDR: 1***" displayed?
3 Check the failure parts
Is the "ADDR: 30**" displayed?
4 Check the failure parts
Is the "ADDR: 31**" displayed?
Check the failure parts
5
Is the "ADDR: 32**" displayed?
Check the failure parts
6
Is the "ADDR: 33**" displayed?
Wiring and Plug/Jack Map References
Imaging Unit, Dispenser, Fuser" on
page 10-8
MCU" on page 10-11
Down Arrow, Up Arrow, and
Error Messages and Codes
"Map 1 - Transfer Unit, Control Panel,
"Map 4 - Toner Dispenser Motors, HVPS,
"Xerographic" on page 10-24
OK buttons simultaneously to
Yes No
Go to step 2. Complete
Replace the Go to step 3.
MCU Board
(page 8-59).
Replace the Go to step 4.
Transfer Unit
(page 8-41).
Replace the Go to step 5.
Yellow Toner
Cartridge.
Replace the Go to step 6.
Magenta Toner
Cartridge.
Replace the Replace the
Cyan Toner Black Toner
Cartridge. Cartridge.
3-75