Xerox Phaser 6130 Service Manual page 133

Phaser 6130 Color Laser Printer Service Manual
Troubleshooting Procedure Table (continued)
Step Actions and Questions
11 Check the paper lead edge stopping
position
Does the paper lead edge stop before
the Registration Roller and Metal
Registration Roller?
12 Check the paper transfer path between
the Feed Roller Assembly and
Registration Roller.
Are there any obstacles on the paper
transfer path?
Check the Regi In Actuator for shape
13
and operation.
Are the shape and operation of the
Regi In Actuator normal?
Check the Regi Roll Actuator for shape
14
and operation.
Are the shape and operation of the
Regi Roll Actuator normal?
Perform the Regi. Sensor test:
15
Mode > Engine Diag > Sensor Test >
Regi Sensor.
Does the number on the screen
increase by one, when the Regi In
Actuator is operated?
16 Check the connections between the
MCU Board and Main Drive Assembly
(Main Motor).
Are P/J21 and P/J211 connected
correctly?
Check the power to the Main Drive
17
Assembly
Disconnect J21 from the MCU Board.
Are the voltages across J21-2/J21-4
<=> ground on the MCU Board, about
+24 VDC when the Front Cover
interlock switch is pushed?
Check the connections between the
18
MCU Board and Feed Solenoid.
Are P/J23 and P/J231 connected
correctly?
Error Messages and Codes
Yes
Go to step 12.
Remove the
obstacles from
the paper
transfer path.
Go to step 14.
Go to step 15.
Service Replace the
MCU Board
(page 8-59).
Go to step 17.
Replace the
Main Drive
Assembly
(page 8-52).
Go to step 19.
No
The paper lead
edge stops past
the Registration
Roller and Metal
Regi Roller.
Go to step 14.
Go to step 13.
Reseat the Regi
In Actuator. If
broken or
deformed,
replace the
Feeder
Assembly
(page 8-25).
Reseat the Regi
Roll Actuator. If
broken or
deformed,
replace the
Feeder
Assembly
(page 8-25).
Go to step 22.
Reconnect the
connector(s) P/
J21 and/or P/
J211 correctly.
Replace the
MCU Board
(page 8-59).
Reconnect the
connector(s) P/
J23 and/or P/
J231 correctly.
3-31