Xerox Phaser 6130 Service Manual page 142

Error Messages and Codes
3-40
Troubleshooting Procedure Table (continued)
Step Actions and Questions
20 Check the Manual Feed No Paper
Sensor (Photo Sensor) for operation
Check the voltage across J23-8pin <=>
ground on the MCU Board.
Does the voltage change, when the SSI
Actuator is operated?
Check the connectors of the Regi
21
Sensor (Photo Sensor) for connection
Check the connections between the
MCU Board and Regi Sensor (Photo
Sensor).
Are P/J23 and P/J232 connected
correctly?
Check the Left Side Harness Assy for
22
continuity
Disconnect J23 from the MCU Board.
Disconnect J232 from the Regi Sensor
(Photo Sensor).
Is each cable of J23 <=> J232
continuous?
23 Check the power to the Regi Sensor
(Photo Sensor)
Disconnect J23 from the MCU Board.
Is the voltage across P23-3pin <=>
ground on the MCU Board about +3.3
VDC?
24 Check the Regi Sensor (Photo Sensor)
for operation
Check the voltage across J23-5pin <=>
ground on the MCU Board.
Does the voltage change, when the
Regi Roll Actuator is operated?
Check the connectors of the Drive
25
Clutch Assy (Regi Clutch) for
connection
Check the connections between the
MCU Board and Drive Clutch Assy.
Are P/J26 and P/J262 connected
correctly?
Check the HARN ASSY KSNR REGCL
26
for continuity
Disconnect J26 from the MCU Board.
Disconnect P262 from the Drive
Clutch Assy (Regi Clutch).
Is each cable of J26 <=> P262
continuous?
Yes
Replace the
MCU Board
(page 8-59).
Go to step 22.
Go to step 23.
Go to step 24.
Replace the
MCU Board
(page 8-59).
Go to step 26.
Go to step 27.
Phaser 6130 Color Laser Printer Service Manual
No
Replace the
Feeder
Assembly
(page 8-25).
Reconnect the
connector(s) P/
J23 and/or P/
J232 correctly.
Replace the
Feeder Assy
(page 8-25) or
Left Side
Harness Assy
(page 8-26).
Replace the
MCU Board
(page 8-59).
Replace the
Feeder
Assembly
page 8-25.
Reconnect the
connector(s) P/
J26 and/or P/
J262 correctly.
Replace the
HARN ASSY
KSNR REGCL.