Consumables/Routine Maintenance Part Errors; Fuser Error; Fuser Error (Open Fuser Error) - Xerox Phaser 3250 Service Manual

Error Messages and Codes

Consumables/Routine Maintenance Part Errors

Fuser Error

Applicable Error Message
Initial Actions
3-18
All LED's are blinking. There is a Fuser error.
Warning
The Fuser may be hot. Turn the printer power Off and allow at least 5 minutes
for the Fuser to cool before removing the Fuser.
Open Fuser Error
Low Heat Error
Overheat Heat Error
Fuser Empty
Fuser Door Error
Fuser Fan Lock Error
Diagnose Low Heat
Ensure that the Fuser is secured to the printer.
Cycle printer power.
If the problem persists, refer to the following procedure.
Troubleshooting Reference Table
Applicable Parts
Fuser, PL9.1.0
Thermistor Assembly, PL9.1.5
Thermostat, PL9.1.7
Halogen Lamp, PL9.1.30
Wiring and Plug/Jack Map Reference
"Map 7 - LVPS, HVPS, Fuser, Developer
Unit CRUM, and Power Switch" on
page 10-15
Phaser 3250 Laser Printer Service Manual