Insert Imaging Unit - Xerox Phaser 6130 Service Manual

Insert Imaging Unit

Phaser 6130 Color Laser Printer Service Manual
Troubleshooting Procedure Table
Step Actions and Questions
Check the life counter value of the
1
Transfer Belt:
Parameter
Is the life count value near the
maximum?
Initial Actions
Cycle printer power.
Ensure the Imaging Unit is installed correctly.
If problem persists, follow the procedure below.
Troubleshooting Reference Table
Applicable Parts
MCU Board, PL8.2.13
Imaging Unit, PL4.1.21
Troubleshooting Procedure Table
Step Actions and Questions
1 Check the connectors between the
MCU Board and Imaging Unit.
Are P/J42 and P/J422 connected
securely?
Does the error still occur when the
2
power is turned OFF and ON?
3 Does the error still occur when the
power is turned OFF and ON?
Service Mode >
> Life DTB Waste.
Wiring and Plug/Jack Map References
"Map 1 - Transfer Unit, Control Panel,
Imaging Unit, Dispenser, Fuser" on
page 10-8
"Map 4 - Toner Dispenser Motors, HVPS,
MCU" on page 10-11
"Xerographic" on page 10-24
Error Messages and Codes
Yes No
Replace the Replace the
Transfer Unit MCU Board
(page 8-41). (page 8-59).
Yes No
Replace the Securely
Imaging Unit reconnect P/J42
(page 8-8), then and/or P/J422,
go to step 3. then go to step
2.
Go to step 3. Complete
Replace the Complete
MCU Board
(page 8-59).
3-53