Jam At Front Cover - Xerox Phaser 6130 Service Manual

Error Messages and Codes

Jam at Front Cover

Initial Actions
3-34
Paper fed from Paper Tray arrived at or left the Registration Sensor early.
Check the paper path for obstructions or debris.
Cycle printer power.
If the problem persists, follow the procedure below.
Troubleshooting Reference Table
Applicable Parts
Drive Clutch Assy Kit (PL3.1.99)
Left Side Harness Assy (PL3.1.18)
Feeder Assy NV (PL3.1.3)
Photo Sensor (PL3.2.13)
MCU Board (PL8.2.13)
Troubleshooting Procedure Table
Step Actions and Questions
1 Check the paper setting
Was the paper setting for the Tray
correct?
2 Does the error still occur when
printing?
Using your finger, check the
3
Registration Roller and Metal
Registration Roller for contact
Does the spring force on both sides of
the Metal Registration Roller hold it
firmly in contact with the Registration
Roller?
4 Perform the Regi Clutch test
(page 4-33): Service Mode > Engine
Diag > Motor Test > Regi
Does the Regi Clutch operate
properly?
Wiring and Plug/Jack Map References
"Map 2 - Laser Unit, Feeder Assembly"
on page 10-9
"Map 4 - Toner Dispenser Motors, HVPS,
MCU" on page 10-11
"Feeder, Manual Feed, & Registration" on
page 10-19
Yes
Go to step 3.
Go to step 3.
Go to step 4.
Go to step 5.
Clutch.
Phaser 6130 Color Laser Printer Service Manual
No
Enter the correct
paper setting,
then go to step
2.
Complete.
Replace the
Feeder Assy NV
(page 8-25).
Go to step 6.