Xerox Phaser 6130 Service Manual page 140

Error Messages and Codes
3-38
Troubleshooting Procedure Table (continued)
Step Actions and Questions
6 Check the Front Cover for latching
Open and close the Front Cover, and
then latch correctly.
Does the error still occur when
printing?
7 Check the paper lead edge stopping
position
Does the paper lead edge stop before
the Registration Roller and Metal Regi
Roller?
8 Check after resetting the guide sides of
the Manual Feed Slot
Reset the side guides.
Does the error still occur when
printing?
9 Check the paper transfer path between
the Manual Feed Slot and Regi.Sensor
Are there any obstacles on the paper
transfer path?
Does the error still occur when
10
printing?
11 Check the SSI Actuator for shape and
operation
Are the shape and operation of the SSI
Actuator normal?
12 Check the Manual Feed Sensor (Photo
Sensor) for operation
Perform the Manual Feed Sensor test:
Service Mode > Engine Diag > Sensor
Test > Manual Feed Sensor
Does the number on the screen
increase by one, when the actuator
(Actuator SSI) is operated?
Yes
Go to step 7.
Go to step 8.
Go to step 9.
Remove the
obstacles or
stain from the
paper transfer
path, then go to
step 10.
Go to step 11.
Go to step 12.
Go to step 13.
Phaser 6130 Color Laser Printer Service Manual
No
Complete
The paper lead
edge stops past
the Registration
Roller and Metal
Regi Roller.
Go to step 13.
Complete
Go to step 11.
Complete
Reseat the SSI
Actuator. If
broken or
damaged,
replace the SSI
Actuator.
Go to step 16.