Transfer Unit Errors; Ctd Sensor Error/Ctd Sensor/Check Unit - Xerox Phaser 6130 Service Manual

Transfer Unit Errors

CTD Sensor Error/CTD Sensor/Check Unit

Phaser 6130 Color Laser Printer Service Manual
Applicable Chain Link
092-310: CTD Sensor Error
Initial Actions
Cycle printer power.
If the problem persists, follow the procedure below.
Troubleshooting References Table
Applicable Parts
Left Side Harness, PL3.1.18
MCU Board, PL8.2.13
Transfer Unit, PL6.1.7
Troubleshooting Procedure Table
Step Actions and Questions
1 Check the ADC Sensor Window
Open the Front Cover.
Is the ADC Sensor window dirty?
1. Turn off the power, and gently wipe
2
the ADC Sensor window with a clean
dry cloth or cotton swab.
2. After wiping the window, close the
Front Cover.
Does the error still occur when the
power is turned OFF and ON?
Check the Transfer Unit belt.
3
Open the Front Cover.
Is there any damage on the belt
surface?
Wiring and Plug/Jack Map References
"Map 1 - Transfer Unit, Control Panel,
Imaging Unit, Dispenser, Fuser" on
page 10-8
"Map 4 - Toner Dispenser Motors, HVPS,
MCU" on page 10-11
"Xerographic" on page 10-24
ADC Sensor window
s6130-203
Error Messages and Codes
Yes No
Go to step 2. Go to step 3.
Go to step 3. Complete.
Replace the Go to step 4.
Transfer Unit.
(page 8-41.)
3-51