Xerox Phaser 6130 Service Manual page 160

Error Messages and Codes
3-58
Troubleshooting Procedure Table (continued)
Step Actions and Questions
2 Reset the side guides.
Does the error still occur when
printing?
3 Insert a sheet of paper that is suitable
for the print data and the paper
settings into the Manual Feed Slot.
Does the error still occur when
printing?
4 Check the SSI Actuator for shape and
operation
Are the shape and operation of the SSI
Actuator normal?
5 Check the Manual Feed Sensor (Photo
Sensor) for operation.
Perform the Manual Feed Sensor test:
Service Mode > Engine Diag > Sensor
Test > Manual Feed Sensor
Does the number on the screen
increase by one, when the SSI
Actuator is operated?
Check the connectors of the Photo
6
Sensor (SSI No Paper Sensor) for
connection
Check the connections between the
MCU Board and Photo Sensor (SSI No
Paper Sensor).
Are P/J23 and P/J233 connected
correctly?
7 Does the error still occur when
printing?
Check the Left Side Harness Assy for
8
continuity
Disconnect J23 from the MCU Board.
Disconnect J233 from the Photo
Sensor.
Is each cable of J23 <=> J233
continuous?
9 Check the power to the Photo Sensor
Disconnect J23 from the MCU Board.
Is the voltage across P23-6pin <=>
ground on the MCU Board, about +3.3
VDC?
10 Check the Photo Sensor for operation
Check the voltage across J23-8pin <=>
ground on the MCU Board.
Does the voltage change, when the SSI
Actuator is operated?
Yes
Go to step 3.
Go to step 4.
Go to step 5.
Replace the
MCU Board
(page 8-59).
Go to step 8.
Go to step 8.
Go to step 9.
Go to step 10.
Replace the
MCU Board
(page 8-59).
Phaser 6130 Color Laser Printer Service Manual
No
Complete
Complete
Reseat the SSI
Actuator. If
broken or
damaged,
replace the SSI
Actuator.
Go to step 6.
Reconnect the
connector(s) P/
J23 and/or P/
J233 correctly,
then go to step
7.
Complete
Replace the
Feeder Assy
(page 8-25) or
Left Side
Harness Assy
(page 8-26).
Replace the
MCU Board
(page 8-59).
Replace the
Feeder Assy.
(page 8-25).