Waste Full, Yellow/Magenta/Cyan/Black Cartridge - Xerox Phaser 6130 Service Manual

Error Messages and Codes

Waste Full, Yellow/Magenta/Cyan/Black Cartridge

Initial Actions
3-28
Troubleshooting Procedure Table (continued)
Step Actions and Questions
3 Replace the Toner Cartridge
(page 8-10).
Does the error still occur?
4 Check the Toner CRUM Harness for
continuity
1. Disconnect J31 from the MCU
Board.
2. Disconnect J311 (Y), J312 (M),
J313 (C) or J314 (K) from the
connector CRUM.
Is each cable of J31 <=> J311, J312,
J313 or J314 continuous?
Reseat plugs and jacks on the MCU
5
Board.
Does the error still occur when the
power is turned OFF and ON?
Measure the voltage at P31-3 <=>
6
Ground.
Is the voltage approximately +3.3VDC?
Check the Toner Cartridge life using CentreWare IS.
Cycle printer power.
If problem persists, follow the procedure below.
Troubleshooting Reference Table
Applicable Parts
Toner Cartridge (Y/M/C/K),
PL5.1.21-24
MCU Board, PL8.2.13
Troubleshooting Procedure Table
Step Actions and Questions
Replace the TONER CARTRIDGE.
1
Does the error still occur when turning
of and on the power?
Yes
Go to step 4.
Go to step 5.
Go to step 6.
Replace the
Dispenser
Assembly
(page 8-34)
Wiring and Plug/Jack Map References
"Map 1 - Transfer Unit, Control Panel,
Imaging Unit, Dispenser, Fuser" on
page 10-8
"Map 4 - Toner Dispenser Motors, HVPS,
MCU" on page 10-11
"Developer" on page 10-27
Yes
Replace the
MCU Board.
(page 8-59)
Phaser 6130 Color Laser Printer Service Manual
No
Complete.
Replace the
Dispenser
Assembly
(page 8-34)
Complete.
Replace the
MCU Board
(page 8-59).
No
Complete.