Xerox Phaser 6130 Service Manual page 217

Phaser 6130 Color Laser Printer Service Manual
Regi Clutch
The Regi clutch controls the drive to the Registration Roller.
Caution
When performing this procedure, remove and cover the Imaging Unit to
avoid exposure to light.
1. Enter the Service Diagnostic menu (page 4-5).
2. Open the Front Cover.
3. Remove the Imaging Unit (page 8-8).
4. Use a paper clip to secure the Interlock Switch.
5. Perform the Main Motor FULL2 test:
Motor FULL2.
6. While the Main Motor is running, press the Up Arrow button to find
Clutch. Press the OK button to run the Regi Clutch test.
Note
The Registration Rollers rotate when the Main Motor FULL2 and the
Registration Clutch tests are executed.
7. Verify that the Main Motor is running and the Registration Rollers are
rotating.
Registration Rollers
8. Press the Cancel button to stop the Regi Clutch test.
9. Press the Down Arrow button to find
10. Press the Cancel button to stop the Main Motor test.
11. Remove the paper clip from the Interlock Switch.
12. Press the Cancel button to stop the ADC Sensor Solenoid test.
13. Remove the paper clip from the Interlock Switch.
General Troubleshooting
Engine Diag > Motor Test
Main Motor FULL2.
> Main
Regi
s6130-197
4-33