Xerox Phaser 6130 Service Manual page 231

Phaser 6130 Color Laser Printer Service Manual
Troubleshooting Procedure Table (continued)
Step Actions and Questions
6 Check the setting of the Manual Feed Slot
paper guides
Were the paper guides correctly set, and
was the paper correctly inserted into
Manual Feed?
Check the paper condition
7
Is the paper dry and approved paper?
8 Check noise when the paper is fed from the
Manual Feed
Does the noise come from the printer?
9 Perform the Main Motor test (page 4-27):
Service Mode > Engine Diag
> Main Motor FULL2.
Does the noise arise from the printer?
10 1. Reseat the Imaging Unit.
2. Perform the Main Motor test (page 4-27):
Service Mode
Test > Main Motor
Is the noise still present?
11 1. Reseat the connectors on the Transfer
Unit.
2. Perform the Main Motor test (page 4-27):
Service Mode
Test > Main Motor
Is the noise still present?
Are there any foreign substances on the
12
surfaces of the Registration Roller
Assembly and Metal Registration Roller?
13 Check noise when printing
Is the noise still present?
Check the Registration and Metal
14
Registration Rollers for rotation
1. Start the Main Motor test (page 4-27):
Service Mode
Test > Main Motor
motor is running start the Regi Clutch
test: Service Mode
Motor Test > Regi
Is the noise coming from the Roller(s)?
> Motor Test
> Engine Diag > Motor
FULL2.
> Engine Diag > Motor
FULL2.
> Engine Diag > Motor
FULL2, and while the
> Engine Diag >
Clutch.
General Troubleshooting
Yes No
Go to step 7. Reset the
paper guides,
and insert the
paper
correctly in
the Manual
Feed Slot,
then go to
step 7.
Go to step 9. Replace with
dry and
approved
paper, then
go to step 8.
Go to step 9 Complete
Go to step 10. Go to step 16.
Go to step 11. Complete
Go to step 12. Complete
Remove the Go to step 14.
foreign
substances,
then go to
step 13.
Go to step 14. Complete
Replace the Go to step 15.
Registration
Roller
Assembly
and/or Metal
Registration
Roller.
4-47