Relationship Between System Program And Hardware - Omron Programmable Terminals NT631 Setup Manual

Relationship between system program and
Here, relationship between system program and hardware is described.
System programs indicated below are installed for the models shown above in the default state. Also, system
programs are supplied with the Support Tool as follows.
Model
NT631-ST211@-E
NT631C-ST141@-E
NT631C-ST151@-E
NT631-ST211@-EV1
NT631C-ST141@-EV1
NT631C-ST151@-EV1
NT631-ST211@-EV2
NT631C-ST141@-EV2
NT631C-ST151@-EV2
NT631C-ST152@-EV2
NT631C-ST153@-EV3
Note NT System Installer version 2.0 or higher is required to transfer the NT631-EV3-compatible system pro-
gram. (NT System Installer version 2.0 is provided with the NT-series Support Tool version 4.08 or
higher.)
These system programs have mutual compatibility, therefore, they can be installed and used for NT631-
ST211 /NT631C-ST141
@-E
ST151 -EV1, and NT631-ST211
@
each.
However, there will be a limitation on function depending on the combination. Refer to the following table.
System program version 4.0
pre-version-2 hardware. System program earlier than Ver. 3.1
The following table shows only the relationship between the hardware and system program.
For details of the relationship with the screen data created using the Support Tool, refer to NT-series Support
Tool for Windows (Ver. 4.
Appendix I
hardware
History
Conventional product
Version upgrade of the
above products
(December 1998)
Version upgrade of the
above products
(December 1999)
Version upgrade of the
above products
(October 2004)
Version upgrade of the
above products
(September 2006)
/NT631C-ST151
-E @-E
-EV2/NT631C-ST141
@
is only for NT631C-ST153
@
@ ) Operation Manual (V061-E1-
System Program version 1.@
(supplied with the
NT-ZJCMX1-EV2)
System Program version
2.0@ or 2.1@
(supplied with the
NT-ZJCMX1-EV3)
System Program version
3.0@ or 3.1@
(supplied with the
NT-ZJCMX1-V4.00)
System Program version
3.1@
(supplied with the
NT-ZJCMX1-V4.05)
System Program version
4.1@
(supplied with the
NT-ZJCMX1-V4.08)
, NT631-ST211 -EV1/NT631C-ST141
@
-EV2/NT631C-ST151
@
. The system program cannot be installed in
@-EV3
cannot be installed in NT631C-ST153
@
@ ).
System program
Same for pre-version-1 and
version-2 hardware, but
there are restrictions to
some functions depending
on the hardware version that
is installed.
Only for hardware for ver-
sion-3 (EV3) PTs. Cannot be
installed with pre-version-1
or version-2 hardware.
-EV1/NT631C-
@
-EV2/NT631C-ST152
@
-EV2
@
.
@-EV3
277