Omron Programmable Terminals NT631 Setup Manual page 230

System Maintenance
Checking
Communications with a
Printer
Check communications with a printer by following the menu operation from
the System Menu shown below.
Ver 4.12
• While data is being sent to the printer, the message Checking Now... is
displayed.
• When the sending of data to the printer is completed, Finished Normal by
Printer Interface Check is displayed.
Select Maintenance Mode.
Select I/O Check.
Select I/F Check.
Select Printer.
Confirm that a printer is connected to the
NT631/NT631C, then press Execute:
Printer Interface Check will be printed out
at the printer.
Section 6-11
213