Operations In The System Installer Mode; Setting The Display Language In The System Installer Mode - Omron Programmable Terminals NT631 Setup Manual

Operations in the System Installer Mode

6-5

Operations in the System Installer Mode

6-5-1

Setting the Display Language in the System Installer Mode

144
After initialization, the memory switch statuses are as follows.
Memory Switch
Start-up Wait Time
Key Press Sound
Buzzer Sound
Printer Controller
Print Method
Screen Saver Movement
Screen Saver Start up Time
Hist. Disp. Method
Resume Function
Comm. Auto-return
Time-out Interval
Retry Counts
Comm. A Method
Comm. B Select
Comm. B Method
* The communications conditions for a bar code reader are initialized as fol-
lows:
Data bits: 7 bits; stop bit: 1 bit; parity: none; flow control: RS/CS.
The following functions can be executed in the System Installer mode:
• Setting the display language (see below)
• Clearing/installing the system program (page 145)
• Disabling/enabling display of the System Menu (changing the system set-
tings) (page 147)
• Disabling/enabling writing to the screen data memory (changing the sys-
tem settings) (page 147)
• Clearing screen data (page 148)
For details on calling the System Installer mode, refer to Calling the System
Installer Mode (page 134).
The version code displayed beside the System Installer title on the screen
indicates the version of the System Installer Mode. For details, refer to 3-5
Using a Memory Unit.
The first setting made in the System Installer mode is to select whether the
display language is to be English or Japanese.
Status
00
ON
OFF
ESC/P
Tone (NT631C only)
Display erased
010
From New Data
OFF
OFF
01
005
Host Link (communications speed = 9600 bps)
RS-232C
None
Section 6-5
*