Omron Programmable Terminals NT631 Setup Manual page 159

Memory Initialization
Reference:
142
When the memory tables are initialized, they are returned to their initial values
regardless of the setting made for the resume function (page 177).
If ON is set for the Resume Function memory switch, the initial values set with
the Support Tool will not be recorded in the memory tables unless they are ini-
tialized.
• If OFF is set for the Resume Function memory switch, the memory tables
can be initialized just by switching the NT631/NT631C power off and back
on again, or by resetting the NT631/NT631C (page 177).
• The bit memory table merely reflects the statuses of bits at the host and
therefore cannot be initialized.
Initialize the memory tables by following the menu operation from the System
Menu shown below.
Ver 4.12
Select Maintenance Mode.
Select Memory Init..
Select Memory Table.
Select Yes.
The memory tables are initialized.
During initialization, the message
Initializing is displayed.
Section 6-4