Suspension Arm Installation - Honda TRX500FM Service Manual

FRONT WHEEUSUSPENSION/STEERING
Sel the upper arm (1) and special tools with "A" marl< 12)
side of the remove r/installer facing to the ball joint [3) in
the hydraulic press as shown.
Press the ball ;oint out of the upper arm.
TOOLS :
[4) Ba ll joint remover/installer 07WMF·HN001 00
(5J Attachment, 28)( 30 mm 07946-1870100
Set the upper arm PI and special lools with "8" mark 121
side of t he remover/installer facing to the ball joint (3] as
shown.
Press the ball joint into the upper arm until it is fully
seated.
TOOLS:
(4) Ball joint remover/installer 07WMF·HN00100
[5] Attachment, 20 mm I.D. 07746-0020400
I
NOTICE
I
If you feel strong resistance when lowering the press,
stop. Reset the attachment of the tool so that the ball
Joint head can go into the hollow of the attachment and
try again.
Install the snap ring (1) with the chamfered edge facing
in .
INSTALLATION
Apply molybdenum disulfide grease to the inner
surfaces of the pivot bushings (1
J
and install the pivot
collar (2) into the upper arm.
Apply molybdenum disulfide grease to the lips of new
dust seal caps (3) and inslalilhem onto the upper arm .
131
j
121
16·25