Front Drive Shaft Installation - Honda TRX500FM Service Manual

NOla the installa/ion
Inslall the band A (1] and a new band B [2] onto the
direction of the inboard boot.
band (page 19-9). Bend down each band end and secure it with the lock
tabs [3J. Tap the lock tabs with a plastic hammer.
Install the shaft boot band [1
J
and a new outboard boot
band [2] onto the outboard boot.
Bend down the band end and secure it with the lock
labs [3J. Tap the lock tabs with a plastic hammer.
INSTALLATION
Install a new stopper ring [1] into the groove In the
inboard joint spline.
B6 careful not
10 Install the drive shaft by holding the inboard joint [1]
damage (he oil seal
until the stopper ring seats in the groove of the
In
the gear case. differential.
Make sure that the stopper ring is sealed properly by
pulling on the inboard jOint lightly.
Install the knuckle (page 16-22).
[1
FRONT DRIVING MECHANISM
[2[
....
19-11