Injector Side - Honda TRX500FM Service Manual

3. Pull and release the connector damper [1] from the I
retainer.
4. Hold the connector [2) with one hand and squeeze
the retainer [3] tabs with the other hand to release
them from the locking pawls [4J.
If using the special tool:
Pull and release the connector damper [1] from the
retainer as shown.
Set the special tool to the retainer tabs and push and
release them from the locking pawls
TOOL:
[5J Fuel connector remover 070MF-HP50200
Pull the connector off, then remove the retainer and
connector damper from the pipe end.
NOTE :
Absorb the remaining fuel in the fuel feed hose from
Howing out with a shop towel.
Be careful not to damage the hose o r other parts.
Use the specified special tool only.
If the connector does not move, keep the retainer
tabs pressed down, and alternately pull and push
the connector until il comes off easily
FUEL SYSTEM
[2[
[4[
[1[
[3[
[1 [
[5[
I
j
5. To prevent damage and keep foreign matter out,
cover the disconnected connector and pipe end with
the plastic bags [1 ).
INJECTOR SIDE
1. Relive the fuel pressure (page 7-6).
Remove Ihe throttle body cover (page 7-13).
Remove the bolt (1] , clamp (2] and setting rubber (3].
[1[
j
7-7