Throttle Body Removal - Honda TRX500FM Service Manual

Be
careful nollo
damage the
crankcase breather
-
Disconnecllhe tAT sensor 2P (Black) connector [11 and
r -
the crankcase breather hose (21 .
Release the rear final gear case breather hose clip (3)
from the air cleaner houSInQ (4).
loosen the connecting
lube
band screw [5J.
Remove the two trim clips [61 and the air cleaner
housing.
Installation is in the reverse order of removal.
THROTTLE BODY
NOTE :
If the sensor unit is removed from the throttle body,
the TP sensor reset procedure must be performed
after installing the throttle body (page 4·31).
REMOVAL
FUEL SYSTEM
151
(41
,
(21 131
Relieve the fuel pressure and disconnect the quick
,----...--r.:,...,.
connect fitting from the fuel injector (page 7-7).
Remove the air cleaner housing (page 7-22).
Oisconnect the IACV 4P (Black) connector (1) . fuel
injector 2P (Gray) connector [21 and sensor unit SP
(Black) connector [3).
Loosen the throltle body side insulator band screw [11.
Remove the throttle body (21 from the insulator.
L
7-23