Crankcase Separation - Honda TRX500FM Service Manual

CRANKCASEITRANSMISSION/CRANKSHAFT/BALANCER
CRANKCASE SEPARATION
Remove the following:
- engine (page
15-4)
cylinder head (page 10-9)
cylinder and piston (page 11-4)
gearshift linkage (page 12.19)
change clutch (page 12-13)
oil pump (page 9-4)
flywheel and starter clutch (page 13-11)
reverse stopper shaft assembly 11]
output shaft drive gear [2J, driven gear [3J and output
shaft [4]
- two front crankcase bolts [1]
Loosenthe -
fifteen rear crankcase bolls (1)
crankcase
bolts in
a
cnssClOSS pattem in
several steps.
Do not PlY
the
cnmkCBS6 apart
with
a
screwdriver.
Place the crankcase assembly with the rear crankcase
down.
Remove the front crankcase while tapping It at several
locations with a soft hammer.
Remove the three dowel pins (1).
Remove any sealant material from the crankcase
mating surfaces.
111
14·7