Camshaft Removal - Honda TRX500FM Service Manual

CYLINDER HEADNALVE
Install the ignition coil primary wire clip [1) to Ihe ignition
coil bracket 12].
Connecllhe ECT sensor 2P connector 13] and ignition
coil primary connectors {4].
Inslalilhe following:
- quick connect fitting (page 7-9)
- fuel lank (page 7-20)
CAMSHAFT REMOVAL
Remove the following:
- cylinder(page 11-4)
- primary drive gear (page 12-13)
Malt the
followers
Remove Ihe cam followers [1
J
from the crankcase.
so
they can
be
plaaxi back in their
anginal iocallOfls.
10-20
Push in the tensloner lifter shaft [1] while pressing Ihe
ratchet pawl (2] and insert a pin into the hole [3] to hold
the tensionar lifter shaft.
Remove the two bolts [4) and cam chain tensioner lifter
151·
Remove the following:
- tensioner pivot
bolt [1J
- cam chain tensioner [2]
- washer [3]