CYLINDER HEADNALVE
Do
not tum the line up the camshaft pin [1) and index mark (V ) [2] on
cmnkshaft during
the crankcase with the sprocket hole facing up and
installation.
instatlthe cam chain [3] over the timing sprocket (4] on
the crankshaft.
10-24
Install the camshaft into the crankcase completely and
make sure that the camshaft pin and index mark (\7)
line up.
Apply locking agent to the threads of the setting plate
bolt (1].
Install the bearing selling plate
[2J
onto the crankcase
and tighten the bolt securely.
Apply locking agent to the threads of the tensioner pivot
bolt
]1].
Install the washer
12J
(in between the tensioner and
crankcase), cam chain tensioner
(3J
and pivot bolt, and
tighten the bolt to the specified torque.
TORQUE : 12 N'm (1.2 kgf'm , 9lbHt)
Push in the tensioner lifter shaft (1] while pressing the
ralchet pawl
(21
and insert a pin (31 into the hole to hold
the tensioner lifter shaft.