Honda TRX500FM Service Manual page 427

Install the holder bracket [1) and cover base (2) with the
two bolts (3), and tighten them to the specified torque_
TORQUE : 10 N·m (1 .0 kgf'm, 7 IbHt)
Install the spring (1) onto the selector cable [21-
Insert the cable into the cable holder (31 and connect it
to the clutch arm with the joint pin (41 and adjusting nut
[5).
Set the groove in the cable grommet (6) onto the cover
base end properly _
Install the retaining plate [7} onto the cable with the
concave facing the cable holder to secure the cable .
Adjust the selector cable (page 3- 19).
Install the following :
- drive shaft{s) (page 19-11 )
- en9ine 9uard (page 2-7)
- mudguards (page 2-6)
Fill the gear case with the recommended oil
(page 3-19).
FRONT DRIVING MECHANISM
13]
12]
141
11]
171
19-39