Hds Pocket Tester Usage; How To Connect The Hds Pocket Tester; Reading Dtc With The Gear Position Indicator - Honda TRX500FM Service Manual

Hide thumbs Also See for TRX500FM:
Table of Contents

Advertisement

ELECTRIC SHIFT PROGRAM (ESP: FE/FPE models)
HDS POCKET TESTER INFORMATION
• The HOS can readout the
OTe ,
stored data, current data and other peM condition.
How to connect the HDS Pocket Tester
Turn the Ignition sWitch OFF .
Remove the seat (page 2-4).
Remove the
OLe
111 from the dummy connector 12].
Connect the HOS pocket tester to the Ole .
Turn the ignition switch ON and engine stop sWitch ·0", check the OlG and
stored data.
NOTE '
• Stored data indicates the engine and ESP conditions when the first
malfunction was detected.
PCM
reset
The HOS can reset the
peM
data including the OTG. stored data and some
learning memory.
DTC READOUT
NOTE
L -_ _ _ _ _
---' [ 1[
If the MIL blinks, refer to "PGM-FI Troubleshooting Information" and troubleshoot the PGM-FI system first. Then recheck the
ESP after erasing the PGM-FI OTC.
After performing diagnostic troubleshooting, erase the problem OTC(s) (page
23-12)
and test -ride the vehicl e to be sure that the
problem(s) have been removed.
Connect the HOS pocket tester to the OLC (page
23-11 ).
Read the DTC , stored data and follow the troubleshooting index (page
23-13).
To read the OTC without the HOS pocket tester, refer to the following procedure.
Reading DTe with the gear position indicator
Turn the ignition switch
ON
and engine stop switch
·0·,
read and note the
gear poSition indicator
{II
blinks "- ".
The number of blinks Indicates the current OTC.
Refer to the troubleshooting Index (page
23-13).
When retrieving the stored OTC , refer to the following procedures
1.
Remove the OLC from the dummy connector (page
23-11 ).
2. Short the OLC [1) terminals using the special tool.
TOOL:
[2] SCS service connector
070PZ-ZY30100
Connection : Brown/red - Green
3. Turn the ignition switch ON and engine slop SWitch "0". read and note
the gear position indicator blinks.
The number of blinks indicates the stored OTG.
Refer to the troubleshooting index (page
23-13).
['(R) (N)
1 "'- -
000
[11
(ps)
(X)
1--1
rl
=F
- il
J
LI,=,
I!!!I
2 . . . ·
LE
[2[
23-11
1

Advertisement

Table of Contents
loading

This manual is also suitable for:

Trx500fpmTrx500feTrx500fpe

Table of Contents