Accessory Socket Inspection; Accessory Socket Replacement - Honda TRX500FM Service Manual

LIGHTS/METERS/SWITCHES
ACCESSORY SOCKET
INSPECTION
22-10
Remove the accessory sockel2P (Black) connector (1)
from the frame and disconnect it.
Measure the voltage between the While/black (+) and
Green (-) wire terminals of the wire harness side
connector.
There should
be
battery vollage with the ignition switch
turned
ON .
If there is no voltage, check for brown
ACe
fuse (10 A)
and an open cirruil in the wire harness.
Remove the accessory socket cap [1].
Check for continuity between the White/black wire
terminal of the socket side 2P connector and bottom
center terminal
121
of the sockel, and between the
Green wire terminal and side wall terminal [3).
There should
be
continuity.
If
there is no continuity,
replace the accessory socket
(page 22-10).
REPLACEMENT
Remove the left fuel tank side cover (page 2-5).
Disconnect the accessory sub harness 2P (Black)
connector (1) from the accessory socket (2).
Remove the nut (3) and inner spacer [4]. accessory
socket, outer spacer [5).
Assemble the outer spacer and a new accessory socket
by aligning the groove with the lug, and place them into
the fender.
Install the inner spacer while aligning the holes with the
outer spacer bosses.
Install the nut and tighten it securely.
Connect the accessory sub harness 2P (Black)
connector.
Install the left fuel tank side cover (page 2-5).
141 131 [11