Clean the wire
Clean the wire
Introduction
If streaks appear on printed output or parts of the printed image are missing, clean the
corona assembly wires inside the main unit.
#
NOTE
•
It takes approximately 35 seconds to clean the wires.
•
Wire cleaning cannot be performed during printing.
Clean the wire
Touch 'System' -> 'Maintenance'.
1.
Press 'Start maintenance'.
2.
Touch 'Clean the corona wires' and touch 'Start' .
3.
A wizard opens.
Press 'Next'.
4.
A status message displays.
Press 'Finish'.
5.
Touch 'Stop' to close the 'Maintenance tasks' menu.
6.
Result
If the procedure displays an engine error, contact your local service representative.
352
Chapter 11 - Maintenance and calibration