Step 3 Configuration On The Computer; Centreware Internet Services Setting Items - Fuji Xerox ApeosPort-V 5070 Administrator's Manual

PJL
Enable this setting to accept a job with PJL commands.
The PJL commands are independent of any printer languages. A printer language used in
the data received next can be set independently of the current printer language.
Auto Eject Time
Set the time that the data so far received by the machine is automatically printed since
data is no longer sent to the printer.
Adobe Communication Protocol
Set the protocol defining the communications method between PostScript printers and a
host.
Bi-directional Communication
Configure the parallel port for either half duplex transmission or full duplex transmission.
Note • Adobe Communication Protocol can be configured when the Adobe PostScript 3 Kit (optional) is
• Do not change the default settings for normal use. You may, however, need to change some settings
5
Select [Close] repeatedly until the [Tools] screen is displayed.
6
Select [Close].
Note • Rebooting the machine may be required depending on the settings. When a message displayed on
7
Print a configuration report to confirm that the parallel port is enabled.
For information on how to print a configuration report, refer to "Print Reports" (P.90).
8
Turn off the computer to be connected to the machine.
9
Connect a parallel interface cable to the parallel interface on the computer.
For information on how to connect a parallel interface cable, refer to "Using the Parallel Interface" (P.22).
10
Start the computer.

Step 3 Configuration on the Computer

The following describes the configuration procedures for the computer.
To print from the machine, you need to install a print driver on your computer.
For information on the supported operating systems, refer to "Supported Operating Systems" (P.305).
For information on the driver installation procedure, refer to the manual contained in the Media (Software/Product
Manual).

CentreWare Internet Services Setting Items

You can configure the following setting items using CentreWare Internet Services:
For details on the setting items, click [Help] at the upper right corner of the CentreWare Internet Services screen to see help.
For information on how to start CentreWare Internet Services, refer to "Starting CentreWare Internet Services" (P.298).
Important • To display the online help for CentreWare Internet Services, users need to have the environment to
Receiving buffer size for the parallel interface
([Properties] > [General Setup] > [Memory Settings] > [Parallel])
Port Settings
installed.
depending on the operating system of your computer.
the screen, follow the message and reboot the machine.
connect to the Internet. The communication fee shall be borne by you.
Installation When Using Parallel Port
7
307