Fuji Xerox ApeosPort-V 5070 Administrator's Manual page 541

Error Code
116-390 [Cause] An error occurred in the machine.
[Remedy] Follow the message displayed on the touch screen and initialize the memory of the
machine.
116-391 [Cause] An error occurred in the machine.
116-392
[Remedy] Switch off the machine power, make sure that the touch screen is blank, and then switch
116-393
on the machine power. If the same message is displayed again, contact our Customer
116-394 Support Center.
116-395
116-396
116-397
116-399
116-702
[Cause] A print job was processed using a substitute font.
[Remedy] Check the print data.
116-703 [Cause] Probable causes are as follows:
1)An error occurred during PostScript (optional) processing.
2)An error occurred because of insufficient memory for PostScript processing.
[Remedy] For 1), check the print data.
For 2), increase the value for [PostScript Memory].
116-704 [Cause] An error occurred when reading data on the media.
[Remedy] Check whether the media is inserted correctly.
116-705 [Cause] An error occurred when reading data on the media.
116-706
[Remedy] Use a computer to confirm the content recorded on the media.
116-707
116-708
116-709
116-710 [Cause] The correct document size could not be judged because the receive data exceeded the
HP-GL/2 spool size.
[Remedy] Increase the size assigned to HP-GL/2 auto layout memory.
116-713 [Cause] The job was divided to be printed because of insufficient disk space.
[Remedy] Delete unnecessary data from the hard disk to free up disk space.
116-714 [Cause] An HP-GL/2 (optional) command error occurred.
[Remedy] Check the print data.
116-716 [Cause] An error occurred when reading the data on the media.
116-717
[Remedy] On a computer, confirm the content recorded on the media.
116-720 [Cause] An error occurred during print processing because of insufficient memory.
[Remedy] Stop unnecessary ports or delete unnecessary data to free up disk space.
116-725 [Cause] Failed to write the image log because the image log storage area on the machine is
insufficient.
[Remedy] Execute the operation again.
If this error still is not resolved, take one of the following measures:
In this case, selecting [Low] does not secure the contents of created image logs.
Cause and Remedy
Delete unnecessary image logs.
Change the [Assurance Level] setting for image logs to [Low].
Error Code
15
541