Fuji Xerox ApeosPort-V 5070 Administrator's Manual page 548

15 Problem Solving
Error Code
124-701 [Cause]
[Remedy] Contact our Customer Support Center. You can use any output trays other than the
124-702 [Cause]
[Remedy] Contact our Customer Support Center. You can use any output trays other than the
124-705 [Cause]
[Remedy] Confirm the punch position, and then execute the operation again.
124-706 [Cause]
[Remedy] Confirm the folding setting, and then execute the operation again.
124-708 [Cause]
[Remedy] For 1), check whether the specified size paper is loaded in the tray.
124-709 [Cause]
[Remedy] Reduce the number of pages, or cancel the stapling setting, then try printing again.
124-710 [Cause]
[Remedy] No measure is required. The machine automatically selects the available output
125-311 [Cause]
[Remedy] Switch off the machine power, make sure that the touch screen is blank, and then switch
127-210 [Cause]
127-211
[Remedy] Disconnect the print server cable, and then securely insert the cable into the connector.
127-212
127-213 [Cause]
[Remedy] Update the machine and the Print Server software to the latest versions.
15
127-220 [Cause]
127-221
[Remedy] Disconnect the print server cable, and then securely insert the cable into the connector.
548
Cause and Remedy
The output destination was changed because of the malfunction of the specified
output tray (Side Tray).
defective output tray.
The output destination was changed because of the malfunction of the specified
output tray (Finisher Tray).
defective output tray.
The punch setting was cancelled.
The folding setting was cancelled.
The output destination has been changed to the Output Tray or the Finisher Tray.
The probable causes are as follows:
1)Paper of a different size from the specified is loaded for 2 sided copying.
2)The Punching feature of the Finisher has malfunctioned.
For 2), confirm whether the error code 012-231, 012-232, 012-233, or 012-234 is
displayed on the touch screen, and contact our Customer Support Center.
The document exceeded the maximum number of pages that can be stapled.
The machine cannot output to the output destination specified. A paper size or a paper
type that cannot be output is specified or the output destination fails.
destination. If the paper is not still output from the specified output destination even
after the correct paper size and type is selected, contact our Customer Support Center.
An error occurred in the machine.
on the machine power. If the same message is displayed again, contact our Customer
Support Center.
A communication error occurred between the machine and the Print Server.
Switch off the machine power, make sure that the touch screen is blank, and then switch
on the machine power.
A communication error occurred between the machine and the Print Server.
A communication error occurred between the machine and the Print Server.
Switch off the machine power, make sure that the touch screen is blank, and then switch
on the machine power.