Fuji Xerox ApeosPort-V 5070 Administrator's Manual page 615

Item
Setting Item
Number
Paper size 2
Extended Settings
Setting Item Item Number
Paper position 20
Output quantity 8
Sets the size of paper to be printed. This setting can be made only when
[Paper Tray] is set to [Auto] or [Tray 5]. This setting can be configured only for
cut sheets.
[3] : A3
[4] : A4
[5] : A5
[14] : B4
[15] : B5
[21] : 8.5 x 14
[22] : 8.5 x 13
[23] : 8.5 x 11
[24] : 11 x 17
[0] : Postcard
Important • If [Paper Tray] is set to Trays 1 to 4 or Trays 6, [Paper Size] cannot be set.
Note • When [Preset%] or [Fit to Cut Sheet] is selected for [Reduce/Enlarge], the
machine automatically calculates the magnification based on a
combination of [Original Size] and [Paper Size]. If the magnification,
however, is outside the range of 45-210%, the document will not be
reduced/enlarged, and will be printed at a scale of 100%.
When [2 Up] is selected, the machine automatically calculates the
magnification based on a combination of [Original Size] and 1/2 of [Paper
Size].
Sets the paper position.
[0] (Default) : Without cut sheet feeder (left)
[1] : With cut sheet feeder (center)
Note • When [Without cut sheet feeder (left)] is specified and FF (line feed
command) is received, the machine skips the number of lines specified in
VFU. When [With cut sheet feeder (center)] is specified, the machine
inserts a page break.
• When a continuous form paper is selected for [Original Size], [Paper
Position] cannot be set.
Sets the number of copies to be printed.
[1 to 250] (Default: 1): 1-250 copies
Important • When the output quantity is specified by a client, that number of copies is
printed. After printing, the number set on the control panel is overwritten
with the number newly specified. However, the number of copies specified
from the LPD port will not overwrite the number set on the control panel.
ESC/P-K Emulation
Value
Value
16
613