Fuji Xerox ApeosPort-V 5070 Administrator's Manual page 542

15 Problem Solving
Error Code
116-738 [Cause]
[Remedy] Match the size and orientation of the paper with the form specified, and print again.
116-739 [Cause]
[Remedy] Delete unnecessary data, or free up the space for the form memory.
116-740 [Cause]
[Remedy] Check the print data.
116-741 [Cause]
[Remedy] Delete unnecessary form. The maximum number allowed is 2048.
116-742 [Cause]
[Remedy] Delete unnecessary logo data.
116-743 [Cause]
[Remedy] Increase memory.
116-746
[Cause]
[Remedy] Use the form registered, or register the form.
116-747 [Cause]
[Remedy] Decrease the paper margin value, and then execute the operation again.
116-748 [Cause]
[Remedy] Check the print data.
116-749 [Cause]
[Remedy] Install the font, or set the print driver to replace the font.
116-750 [Cause]
[Remedy] Restore the tray to normal condition or change the Banner sheet tray.
116-751 [Cause]
[Remedy] Delete stored data in the hard disk. If the error still is not resolved, split the file and send
116-752 [Cause]
[Remedy] Execute the operation again. If the error still is not resolved, contact our Customer
15
Note
116-771 [Cause]
116-772
[Remedy] The printed image may be incomplete. Confirm with the sender whether the image has
116-773
116-774
116-775
116-776
116-777
116-778
542
Cause and Remedy
The size and orientation of the form specified are not matched with the paper to be
printed.
The form or logo data cannot be registered because memory for the form and logo data
or memory capacity for the hard disk is insufficient.
A numerical value operation error occurred because a value exceeding the value limit of
the machine was used in the print data.
The form cannot be registered because the number of the form registration exceeds the
maximum number allowed.
The logo data cannot be registered because the number of the logo data registration
exceeds the maximum number allowed.
The logo data or form cannot be registered because the memory for the form and logo
data is insufficient.
The form specified is not registered.
The paper margin value is too large for the HP-GL/2 active coordinates area.
There is no plot data in the HP-GL/2 (optional) print data.
The job was cancelled because the specified font does not exist.
Banner sheet tray malfunction
The process has been canceled because the hard disk is full.
the job again.
The descriptions of the PDF or XPS printing job ticket have a problem.
Support Center.
• XPS stands for XML Paper Specification.
The data was automatically modified because it included an invalid parameter.
a problem, or ask the sender to send the data again. When using the Internet Fax
Forwarding feature, confirm its condition with the e-mail recipient.