Fuji Xerox ApeosPort-V 5070 Administrator's Manual page 475

Error Code
017-729 [Cause] When the machine is used as a print job storage device, print job sending was stopped
temporarily because the number of jobs in the machine exceeded the maximum
receivable volume or the space for spool data was insufficient.
[Remedy] Take one of the following measures:
017-730 [Cause] When the machine is used as a print job storage device, the computer failed to send a
job to the machine because a network error occurred.
[Remedy] Confirm the followings:
If the error still is not resolved, contact our Customer Support Center.
017-731
[Cause] Unable to connect to the POP server.
[Remedy] Confirm the followings:
017-732 [Cause] When the machine is used as a print job storage device, the computer failed to send a
job because the machine is off-line.
[Remedy] Press the <Machine Status> button of the storage destination machine, and set [Print
Mode] to [On-line] on the [Machine Information] screen. If the error still is not resolved,
contact our Customer Support Center.
017-733 [Cause] When the machine is used as a print job storage device, an internal error in the software
is occurred while the job sending to the machine.
[Remedy] Execute the operation again. If the error still is not resolved, contact our Customer
Support Center.
017-734
[Cause] An internal error occurred during processing the AirPrint data.
[Remedy] Send the print job again by using the printer driver or software other than AirPrint. If the
error still is not resolved, contact our Customer Support Center.
017-735 [Cause] Device usage is prohibited.
[Remedy] Execute the operation again. If the error still is not resolved, contact our Customer
Support Center.
017-737 [Cause] Data could not be sent due to memory capacity shortage.
[Remedy] Have your system administrator stop or delete the unnecessary plug-ins. If the error still
is not resolved, switch off the machine power, make sure that the touch screen is blank,
and then switch on the machine power. If the same message is displayed again, contact
our Customer Support Center.
017-738 [Cause] Data could not be sent due to an internal error.
017-739
[Remedy] Switch off the machine power, make sure that the touch screen is blank, and then switch
on the machine power. If the same message is displayed again, contact our Customer
Support Center.
017-740 [Cause] Data could not be sent due to a plug-in activation failure.
[Remedy] Switch off the machine power, make sure that the touch screen is blank, and then switch
on the machine power. If the same message is displayed again, contact our Customer
Support Center.
Cause and Remedy
Set to spool data to the hard disk from the setting of the storage destination machine.
Set [IPP] under [Properties] > [General Setup] > [Memory Settings] to [Spool to Hard
Disk] by CentreWare Internet Services.
Wait for a while and send the job again.
The network cable is connected properly.
The storage destination machine is powered on.
The IPP port of the storage destination machine is enabled.
The IP address of the POP server is set on the machine.
The network cable is connected properly.
Error Code
15
475