Message
The Booklet Staple Cartridge [R2] is out of
staples or not fully inserted. Check the Staple
Cartridge [R2].
* : The messages above are for the Booklet Staple Cartridge [R2]. For the Booklet Staple Cartridge [R3], [R3] is displayed.
Important • The use of booklet staple cartridges not recommended by Fuji Xerox may degrade quality and
performance. Use only booklet staple cartridges recommended by Fuji Xerox.
Note
• If the booklet staple cartridge was not replaced properly, the message remains on the touch screen.
Follow the procedure and replace the booklet staple cartridge again.
• To order a booklet staple cartridge, contact our Customer Support Center.
1
Make sure that the machine is not operating,
and open the finisher front door.
2
Pull out the booklet unit.
3
With grasping the lever of the booklet staple
cartridge, push the booklet staple cartridge
downward. Then, pull out the booklet staple
cartridge upwards.
4
Press the orange buttons on the right and left
sides of the booklet staple cartridge (1), and
open the cover (2).
Replacing Consumables
Solution
Replace staples with new ones.
3
73