Mounting Arm And Pivot Table (32 554 0) - Ford 2002 Bantam Workshop Manual

501-16-26
REMOVAL AND INSTALLATION

Mounting Arm and Pivot Table (32 554 0)

E923 EN
Wipers and Washers
Removal
NOTE: Only disassemble the wiper linkage
when overhauling it.
1. Remove the wiper motor. For additional
information,
2. NOTE: Mark the position of the wiper motor
crank before undoing it.
Detach the wiper motor crank.
• Unscrew the nut from the crank.
• Release the crank from the taper by
moving it back and forth.
3. Detach the wiper linkage from the wiper
motor.
Installation
1. Attach the wiper motor crank.
• Put the crank into position and crew on
the crank nut.
• Clip the wiper linkage into the pivot
points using a suitable hollow tool (e.g. a
socket).
2. Install the remaining components in reverse
order.
refer to 32 524 0 in this section
07/2001 2002 Bantam
501-16-26