Driver Air Bag Open Circuit Or High Resistance - Ford 2002 Bantam Workshop Manual

501-20B-23
DIAGNOSIS AND TESTING (CONTINUED)
CONDITIONS
PINPOINT TEST H: DTC B1932: DRIVER AIR BAG OPEN CIRCUIT OR HIGH RESISTANCE
CONDITIONS
WARNING: Wait at least one minute after disconnecting the battery ground cable before
disconnecting any supplemental restraint system electrical connector. Failure to follow this
instruction may result in personal injury.
H1: CHECK THE DRIVER AIR BAG MODULE CIRCUIT RESISTANCE
08/2001
Occupant Restraints — Passive — Supplemental Air
2.
Bag System
DETAILS/RESULTS/ACTIONS
4 Measure the voltage between:
- the air bag control module C334 pin 2, circuit
94S-JA8 (VT) and pin 9, circuit 91-JA10
(BK/RD) harness side; and
- the air bag control module C1511a pin 2,
circuit 94S-JA8 (VT) harness side and
ground; and
- the air bag control module C1511a pin 3,
circuit 91S-JA8 (BK/OG) and pin 9, circuit 91-
JA10 (BK/RD) harness side; and
- the air bag control module C1511a pin 3,
circuit 91S-JA8 (BK/OG) harness side and
ground.
• Is any voltage present?
Yes
INSTALL a new air bag wiring harness.
REPEAT the self-test; CLEAR the DTCs.
REACTIVATE the system.
Bag and Safety Belt Pretensioner
Supplemental Restraint System (SRS) in
this section.
No
INSTALL a new air bag sliding contact.
REFER to Air Bag Sliding Contact in this
section. REPEAT the self-test; CLEAR the
DTCs. REACTIVATE the system.
to Air Bag and Safety Belt Pretensioner
Supplemental Restraint System (SRS) in
this section.
DETAILS/RESULTS/ACTIONS
1 Deactivate the supplemental restraint system.
REFER to Air Bag and Safety Belt Preten-
sioner Supplemental Restraint System (SRS)
in this section.
501-20B-23
REFER to Air
REFER
2002 Bantam