Ford 2002 Bantam Workshop Manual page 1555

501-16-19
DIAGNOSIS AND TESTING (CONTINUED)
PINPOINT TEST F: THE WIPERS WILL NOT PARK AT THE CORRECT POSITION
CONDITIONS
F1: CHECK THE RELAY – INTERMITTENT WIPE FOR PROPER FUNCTION
1.
Relay – intermittent
wipe C48
F2: CHECK THE POWER SUPPLY (WIPER PARK) OF RELAY – INTERMITTENT WIPE
F3: CHECK THE CIRCUIT FOR INTERMITTENT WIPE AND WIPER PARK FOR OPEN
1.
E9432 EN
Wipers and Washers
2. 3.
2.
Multifunction switch
C15b
DETAILS/RESULTS/ACTIONS
4 Connect a jumper wire between relay socket –
intermittent wipe, connector C48, pin 1, circuit
31S-AK9 (BK/OG) and pin 3, circuit 31S-AK19
(BK/RD).
• Actuate the SINGLE WIPE: Does the wipers
park in the correct position?
Yes
INSTALL a new relay – intermittent wipe.
TEST the system for normal operation.
No
GO TO F2
1 Turn the multifunction switch to the LOW
WIPER SPEED position.
2 Measure the voltage between relay socket –
intermittent wipe, connector C48, pin 1, circuit
31S-AK9 (BK/OG) and ground.
• Is battery voltage indicated?
Yes
GO TO F3
No
GO TO F5
501-16-19
07/2001 2002 Bantam