Serial Cable Information
The information in this section will help you make a serial cable to connect between the printer
and computer.
Refer to the computer documentation to determine the cable requirements on the computers end.
The Pacemark 3410 has the following cable requirements.
•
Shielded, RS-232C cable
•
UL and CSA approved
No more than 50 feet long
•
•
Cannon DB-25P plug (or equivalent) with 25 pins
•
Cannon DB-C2-J9 (or equivalent) connector shell
Serial Interface Signal Requirements
Pin
Signal
1
Protective Ground
2
Transmit Data
3
Receive Data
4
Request to Send
6
Data Set Ready
7
Signal Ground
11
Supervisory Send Data
20
Data Terminal Ready
Pacemark 3410 Service Handbook
Symbol
Direction
PG
Ground
TD
From Printer
RD
To Printer
RTS
From Printer
DSR
From Printer
SG
Ground
SSD
From Printer
DTR
From Printer
4 - 45
Description
Connected to the printer frame
Serial data transmitted to the system
Serial data received by the printer
Always set to low (mark)
Indicates that data can be sent
Ground
Indicates that the printer is not ready to
receive data
Indicates that the printer is not ready to
receive data
Failure Analysis